C Custom - Zodiac
Search our website
Products
Searching...

Shoppingcart

{{articleCount}} 0 {{articleString}} Articles
Previous Product
12 VOLT GENERATORS

12 VOLT GENERATORS

CYCLE ELECTRIC 12 VOLT GENERATOR

Next Product
12 VOLT GENERATOR

12 VOLT GENERATOR

Made in the USA to Harley-Davidson specifications for restoration purposes. It is bolt-on for 1965 thru 1981 Sportster and 1965 thru 1969 Big Twin. Can also be used to replace the 65B Hitachi 82-84 generator by adding an extra ZPN 151038 oil deflector. Can also be used to convert 1936 thru 1964 models from 6 to 12 Volt using a ZPN 151038 oil deflector in stead of the OEM one and discarding the spring.


Specifications

Article number Description Retail price Add to cart
782248
Cycle Electric 12 Volt generator (OEM 29975-65A) 9 719,14 kr

Recommended Retail Prices include 25.00% sales tax.

Prices exclude shipping, import duties and installation.

Prices are based on EUR to SEK interbank rates obtained daily. The interbank rate is the rate that banks trade currency to each other. These prices must be used as a guide.

Polarizing generators and regulators
The following information and instructions are for your use, so your warranty will by in effect. No warranty can be in effect if these instructions are not followed. Whenever any component of a generator charged electrical system is serviced it is necessary to re-polarize the complete system, making sure it has the correct polarity so the system will charge in the right direction. If the system is put into service with the wrong polarity it may result in burned relay points, a dead battery and damage to both the regulator and generator.
Instructions:
1. To polarize a generator system with a mechanical regulator, momentarily connect a jumper wire of adequate gauge (a battery cable is ideal) between the “bat” and the “gen” terminal on the regulator after all wires have been properly connected and before starting the motor.
2. To polarize a generator system with electronic regulator/ rectifier. Before mounting the generator of the vehicle, place the generator on a non conducting work surface (like a wooden bench) and connect the positive terminal of a battery to the armature terminal of the generator. Then momentarily “flash” the negative battery terminal to the generator field terminal.